Mti-wireless-edge MT-120018 Bedienungsanleitung PDF herunterladen

ONLY)

X4 X4

(MT-120018/A

Attach item 1 to the back of the enclosure

using items2, 3, 13 as shown.

Verify that the oriantation of the hole

in item 1 is aligned with the elevation axis.

Use tightening torque of 5.7N/m.

AXIS

ELEVATION

For radio in 45

use this set of holes

in item 1 is aligned with the elevation axis.

AXIS

ELEVATION

Use tightening torque of 5.7N/m.

BASE BRACKET INSTALLATION TO ANTENNA

using items 2,3,4 as shown.

Verify that the oriantation of the hole

Attach item 1 to the back of the antenna

BASE BRACKET INSTALLATION

TO ENCLOSURE

SHEET 2 OF 4

WIRELESS EDGE

RD41169400C/REV-G

11 Hamelacha St. , Afek Industrial Park, Rosh Ha’ayin 48091, Israel

Fax: 972-3-9008901, Tel: 972-3-9008900

www.mtiwe.com

1 2 3 4

ONLY)X4 X4(MT-120018/AAttach item 1 to the back of the enclosure using items2, 3, 13 as shown.Verify that the oriantation of the hole in item 1 is al

Seite 2

Alternately and equally tighten the two M8 boltsup to it's defined tightening torque , in order to prevent unequal pressure on the cast ClampsSTE

Seite 3

Connect base bracket as shown on page 2 Connect item 5 to item 1 (mate the knurledsurfaces) using items 6,7,8,9 as shown. Note: the bolt head shall

Seite 4

Antenna/enclosure base bracketQty: 1Item: 1WIRELESS EDGESHEET 1 OF 4RD41169400C/REV-GBolt M5x16Qty: 4MT-120018/A onlyBolt M8x70Qty: 2Wall/Poll brack

Keine Kommentare

Mti-wireless-edge MT-120018 Bedienungsanleitung